當前位置:首頁  >  技術文章  >  膠囊剔廢拋光機的主要結構及特點

                膠囊剔廢拋光機的主要結構及特點

                更新時間:2022-06-29      點擊次數:817


                A.料斗部分
                B.上槽部分
                C.網筒部分

                D.主軸部分
                E.下槽部分
                F.傳動部分
                G.機架部分
                H.分選部分
                I.電器部分
                J.機座部分
                整機全部采用不銹鋼材料制造;篩筒毛刷選用快速卡裝式連接,拆裝方便,清洗方便;電機轉速由變頻器控制,可承受較大的啟動力矩,運行平穩、可靠;機座配備可轉動滾輪,移動靈活;操作簡單、工作可靠,生產效率高,拋光潔凈度高,剔除廢品。

                I. The capsule filling machine deliver the filled capsule to the slot mouth of polishing machine.(A)

                二、膠囊從入口(B)通過旋轉毛刷將膠囊帶至篩網筒(C)中。

                II. The capsule from the entrance (B)via the rotating brush  is delivered to the net roller (C).

                三、在篩網筒中(D)毛刷對膠囊表面進行拋光和除塵,并對缺帽和固體帽分離而散落的物料,通過真空吸口(E)進行物料回收。

                III. In the net roller (D), brush can get rid of dust and polish the surface of the capsule, as well as defected products and falling substance, recycle the material by vacuum intake mouth (E).

                四、毛刷將膠囊送至篩網筒的出口。(F)。

                IV. The capsule is sent to the exit of net roller by brush(F).

                V. in the separating selecting device (G), through clean compressed air to make defected capsule separated from the qualified capsule and collecting them into the storage. (H).

                VI. Compress the air pressure, it will display on the pressure meter (I)equipped on the filtering valve, it can be adjusted according to different demand.

                VII. The qualified capsule will be delivered through the exit (J).


                版權所有©2024 杭州勝得機械有限公司 All Rights Reserved     備案號:浙ICP備20026319號-1     sitemap.xml
                24小时日本在线视频资源